950 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AAA COMMANDS
AAA
ACCOUNTING DOT1X
aaa accounting dot1x
Overview This command configures the default accounting method list for IEEE
802.1X-based Authentication. The default accounting method list specifies what
type of accounting messages are sent and specifies which RADIUS Servers the
accounting messages are sent to. The default accounting method list is
automatically applied to interfaces with IEEE 802.1X-based Authentication
enabled.
Use the no variant of this command to disable AAA accounting for 802.1X-based
Port Authentication globally.
Syntax
aaa accounting dot1x default {start-stop|stop-only|none} group
{<group-name>|radius}
no aaa accounting dot1x default
Default RADIUS accounting for 802.1X-based Port Authentication is disabled by default
(there is no default server set by default).
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages will be
sent:
• group radius : use all RADIUS servers configured by radius-server host
command.
• group <group-name> : use the specified RADIUS server group configured
with the aaa group server command.
The accounting event to send to the RADIUS server is configured by the following
options:
• start-stop : sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
• stop-only : sends a stop accounting message at the end of a session.
• none : disables accounting.
Parameter Description
start-stop Start and stop records to be sent.
stop-only Stop records to be sent.
none No accounting record to be sent.
<group-name> Server group name.
radius Use all RADIUS servers.
To Next Page
Loading...
Need help?
General
