508 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
CLEAR
POWER-INLINE COUNTERS INTERFACE
clear power-inline counters interface
Overview This command will clear the counters from a specified port, a range of ports, or all
ports on the Power Sourcing Equipment (PSE). If no ports are entered then PoE
counters for all ports are cleared. It will also clear all Power over Ethernet (PoE)
counters supported by the Power Ethernet MIB (RFC 3621).
Syntax
clear power-inline counters interface [<port-list>]
Mode Privileged Exec
Usage The PoE counters are displayed with the show power-inline counters command.
Examples To clear the PoE counters for all ports, use the following command:
awplus# clear power-inline counters interface
Validation
Commands
show power-inline counters
Parameter Description
<port-list> Selects the port or ports whose counters are to be cleared.
To Next Page
Loading...
