C613-50055-01 REV A Command Reference for x230 Series Edge Switches 275
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LOGGING COMMANDS
LOG
PERMANENT SIZE
log permanent size
Overview This command configures the amount of memory that the permanent log is
permitted to use. Once this memory allocation has been filled old messages will be
deleted to make room for new messages.
Syntax
log permanent size <50-250>
Mode Global Configuration
Example To allow the permanent log to use up to 100 kB of NVS use the following
commands:
awplus# configure terminal
awplus(config)# log permanent size 100
Validation
Commands
show log config
Related
Commands
default log permanent
log permanent
Parameter Description
<50-250> Size of the permanent log in kilobytes
To Next Page
Loading...
