172 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
BANNER
EXEC
banner exec
Overview This command configures the User Exec mode banner that is displayed on the
console after you login. The banner exec default command restores the User Exec
banner to the default banner. Use the no banner exec command to disable the
User Exec banner and remove the default User Exec banner.
Syntax
banner exec <banner-text>
banner exec default
no banner exec
Default By default, the AlliedWare Plus™ version and build date is displayed at console
login, such as:
Mode Global Configuration
Examples To configure a User Exec mode banner after login, enter the following commands:
AlliedWare Plus (TM) 5.4.5 03/31/14 00:44:25
awplus#configure terminal
awplus(config)#banner exec enable to move to Priv Exec mode
awplus(config)#exit
awplus#exit
awplus login: manager
Password:
enable to move to Priv Exec mode
awplus>
To Next Page
Loading...
