C613-50055-01 REV A Command Reference for x230 Series Edge Switches 95
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
USER ACCESS COMMANDS
SHOW
PRIVILEGE
show privilege
Overview This command displays the current user privilege level, which can be any privilege
level in the range <1-15>. Privilege levels <1-6> allow limited user access (all User
Exec commands), privilege levels <7-14> allow restricted user access (all User Exec
commands plus Privileged Exec show commands). Privilege level 15 gives full user
access to all Privileged Exec commands.
Syntax
show privilege
Mode User Exec and Privileged Exec
Usage A user can have an intermediate CLI security level set with this command for
privilege levels <7-14> to access all show commands in Privileged Exec mode and
all commands in User Exec mode, but no configuration commands in Privileged
Exec mode.
Example To show the current privilege level of the user, use the command:
awplus# show privilege
Output Figure 2-1: Example output from the show privilege command
Related
Commands
privilege level
awplus#show privilege
Current privilege level is 15
awplus#disable
awplus>show privilege
Current privilege level is 1
To Next Page
Loading...
Need help?
General
