114 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
BOOT
SYSTEM
boot system
Overview Use this command to set the release file to load during the next boot cycle.
Use the no variant of this command to remove the release file as the boot file.
Syntax
boot system <filepath-filename>
no boot system
Mode Global Configuration
You can only specify that the release file is on an SD card if there is a backup release
file already specified in Flash. If you attempt to set the release file on an SD card and
a backup release file is not specified in Flash, the following error message is
displayed:
Examples To run the release file x230-5.4.5-0.1.rel stored on the device’s Flash
filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# boot system flash:/x230-5.4.5-0.1.rel
To remove the release file x230-5.4.5-0.1.rel stored on the device’s Flash
filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# no boot system flash:/x230-5.4.5-0.1.rel
To run the release file x230-5.4.5-0.1.rel stored on the device’s SD card
filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# boot system card:/x230-5.4.5-0.1.rel
To remove the release file x230-5.4.5-0.1.rel stored on the device’s SD card
filesystem the next time the device boots up, use the commands:
awplus# configure terminal
awplus(config)# no boot system card:/x230-5.4.5-0.1.rel
Parameter Description
<filepath-filename> Filepath and name of a release file.
The specified release file must exist and must be stored
in the root directory of the specified filesystem.
Valid release files must have a . rel extension.
% A backup boot image must be set before setting a current boot
image on card
To Next Page
Loading...
Need help?
General
