174 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
BANNER
LOGIN (SYSTEM)
banner login (system)
Overview This command configures the login banner that is displayed on the console when
you login. The login banner is displayed on all connected terminals. The login
banner is displayed after the MOTD (Message-of-the-Day) banner and before the
login username and password prompts.
Use the no banner login command to disable the login banner.
Syntax
banner login
no banner login
Default By default, no login banner is displayed at console login.
Mode Global Configuration
Examples To configure a login banner to be displayed when you login, enter the following
commands:
awplus#configure terminal
awplus(config)#banner login
Type CNTL/D to finish.
authorised users only
awplus(config)#exit
awplus#exit
authorised users only
awplus login: manager
Password:
AlliedWare
Plus (TM) 5.4.5 03/31/14
13:03:59
awplus>
To Next Page
Loading...
