460 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SPANNING TREE COMMANDS
SPANNING
-TREE MODE
spanning-tree mode
Overview Use this command to change the spanning tree protocol mode on the device. The
spanning tree protocol mode on the device can be configured to either STP, RSTP
or MSTP.
Syntax
spanning-tree mode {stp|rstp|mstp}
Default The default spanning tree protocol mode on the device is RSTP.
Mode Global Configuration
Usage With no configuration, the device will have spanning tree enabled, and the
spanning tree mode will be set to RSTP. Use this command to change the spanning
tree protocol mode on the device. MSTP is VLAN aware, but RSTP and STP are not
VLAN aware. To enable or disable spanning tree operation, see the spanning-tree
enable command.
Examples To change the spanning tree mode from the default of RSTP to MSTP, use the
following commands:
awplus# configure terminal
awplus(config)# spanning-tree mode mstp
Related
Commands
spanning-tree enable
To Next Page
Loading...
Need help?
General
