1142 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
EPSR COMMANDS
EPSR
epsr
Overview This command sets the timer values for an EPSR instance. These are only valid for
master nodes.
NOTE: This command will only run on switches that are capable of running as an EPSR
master node. However, even if your switch cannot function as an EPSR master node,
you still need to configure this command on whatever switch is the master within your
EPSR network.
Refer to the manual of your master node’s switch.
CAUTION: Using the “no” variant of this command will remove the specified EPSR
instance.
To Next Page
Loading...
