C613-50055-01 REV A Command Reference for x230 Series Edge Switches 859
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
LOG
auth log
Overview Use this command to configure the types of authentication feature log messages
that are output to the log file.
Use the no variant of this command to remove either specified types or all types of
authentication feature log messages that are output to the log file.
Syntax
auth log {dot1x|auth-mac|auth-web}
{success|failure|logoff|all}
no auth log {do1x|auth-mac|auth-web}
{success|failure|logoff|all}
Default All types of authentication log messages are output to the log file by default.
Mode Interface Configuration
Examples To configure the logging of MAC-Authentication failures to the log file for
supplicants (client devices) connected to interface port1.0.2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth log auth-mac failure
Parameter Description
dot1x Specify only 802.1X-Authentication log messages are output to the log
file.
auth-mac Specify only MAC-Authentication log messages are output to the log
file.
auth-web Specify only Web-Authentication log messages are output to the log
file.
success Specify only successful authentication log messages are output to the
log file.
failure Specify only authentication failure log messages are output to the log
file.
logoff Specify only authentication log-off messages are output to the log file.
Note that link down, age out and expired ping polling messages will be
included.
all Specify all types of authentication log messages are output to the log
file Note that this is the default behavior for the authentication logging
feature.
To Next Page
Loading...
Need help?
General
