362 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SWITCHING COMMANDS
SHOW
PORT-SECURITY INTERFACE
show port-security interface
Overview Use this command to show the current port-security configuration and the switch
port status.
Syntax
show port-security interface <port>
Mode Privileged Exec
Example To see the port-security status on port1.0.1, use the following command:
awplus# show port-security interface port1.0.1
Output Figure 10-12: Example output from the show port-security interface command
Parameter Description
<port> The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
Port Security configuration
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 3
Total MAC ddresses : 1
Lock Status : UNLOCKED
Security Violation Count : 0
Last Violation Source Address : None
To Next Page
Loading...
