12
404 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Spanning Tree
Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
RSTP, STP or MSTP. For information about spanning trees, including configuration
procedures, see the STP Feature Overview and Configuration Guide.
Command List •“clear spanning-tree statistics” on page 406
•“clear spanning-tree detected protocols (RSTP and MSTP)” on page 407
•“debug mstp (RSTP and STP)” on page 408
•“instance priority (MSTP)” on page 412
•“instance vlan (MSTP)” on page 414
•“region (MSTP)” on page 416
•“revision (MSTP)” on page 417
•“show debugging mstp” on page 418
•“show spanning-tree” on page 419
•“show spanning-tree brief” on page 422
•“show spanning-tree mst” on page 423
•“show spanning-tree mst config” on page 424
•“show spanning-tree mst detail” on page 425
•“show spanning-tree mst detail interface” on page 427
•“show spanning-tree mst instance” on page 429
•“show spanning-tree mst instance interface” on page 430
•“show spanning-tree mst interface” on page 431
•“show spanning-tree mst detail interface” on page 432
•“show spanning-tree statistics” on page 434
To Next Page
Loading...
Need help?
General
