1258 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF LINKS
show atmf links
Overview This command displays brief information about AMF links on a device, such as link
status and adjacent nodes.
Provisioned node names will be displayed with a trailing * character, and will not
have an entry under Adjacent Ifindex.
This command can only be run on AMF master and controller nodes.
Syntax
show atmf links
Mode User Exec and Privileged Exec
Example To display the AMF links brief details, use the following command:
controller-1# show atmf links brief
Figure 35-8: Sample output from the show atmf links command
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Related
Commands
no debug all
clear atmf links statistics
show atmf
show atmf nodes
device1# show atmf link brief
ATMF Links Brief:
Local Link Port ATMF Adjacent Adjacent Link
Port Type Status State Node Ifindex State
--------------------------------------------------------------------------------
sa1 Crosslink Up TwoWay Building_1 4501 Forwarding
1.0.1 Downlink Up Full Bld1_Floor_1 5001 Forwarding
1.0.2 Downlink Up Full Bld1_Floor_2 5003 Forwarding
1.0.3 Downlink Up Full Bld2_Floor_1 6101 Forwarding
1.0.4 Crosslink Down Init *device3 Blocking
* = provisioned
To Next Page
Loading...
