202 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
ECOFRIENDLY
show ecofriendly
Overview This command displays the switch’s eco-friendly configuration status. The
ecofriendly led configuration status are shown in the show ecofriendly output.
Syntax
show ecofriendly
Mode Privileged Exec and Global Configuration
Example To display the switch’s eco-friendly configuration status, use the following
command:
awplus# show ecofriendly
Output Figure 5-5: Example output from the show ecofriendly command
awplus#show ecofriendly
Front panel port LEDs normal
Energy efficient ethernet
Port Name Configured Status
port1.0.1 Port 1 off -
port1.0.2 off off
port1.0.3 off -
port1.0.4 Port 4 off -
port1.0.5 off -
...
Table 5-3: Parameters in the output of the show ecofriendly command
Parameter Description
normal The eco-friendly LED feature is disabled and port LEDs
show the current state of the ports. This is the default
setting.
off The eco-friendly LED feature is enabled and power to
the port LEDs is disabled.
Port Displays the port number as assigned by the switch.
Name Displays the port name if a name is configured for a
port number.
Configured Because LPI is not supported, this entry always shows
“off” or a dash (-).
Status Because LPI is not supported, this entry always shows
“off” or a dash (-).
To Next Page
Loading...
Need help?
General
