1162 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
EPSR COMMANDS
SHOW
EPSR SUMMARY
show epsr summary
Overview This command displays summary information about all EPSR instances on the
switch
Syntax
show epsr summary
Mode User Exec and Privileged Exec
Example To display EPSR summary information, use the command:
awplus# show epsr summary
Table 34-6: Example output from the show epsr summary command
EPSR Summary Information
Abbreviations:
M = Master node
T = Transit node
C = is on a common segment with other instances
P = instance on a common segment has physical control of the shared port's
data VLAN blocking
LB = ring port is Logically Blocking - applicable to master only
EPSR Ctrl Primary/1st Secondary/2nd
Instance Mode Status State VLAN Prio Port Status Port Status
--------------------------------------------------------------------------------
test-12345 T Enabled Links-Down 6 127 Blocking (C,P) Blocking (C,P)
test1 M Enabled Complete 5 12 Fwding Fwding (LB)
test2 T Enabled Pre-Fwding 4 126 Fwding (C) Blocking (C)
localB T Disabled Idle 40 0 Unknown Unknown
localC T Disabled Idle 41 0 Unknown Unknown
--------------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
