514 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE MAX
power-inline max
Overview NOTE:
The no variant of this command sets the maximum power supplied to a PoE port
to the default, which is set to the maximum power limit for the class of the
connected Powered Device (PD).
Syntax
power-inline max <4000-30000>
no power-inline max
Default The Power Sourcing Equipment (PSE) supplies the maximum power limit for the
class of the PD connected to the port by default.
NOTE: See the PoE Feature Overview and Configuration Guide for further information
about power classes.
Mode Interface Configuration
Usage Select a PoE port, a list of PoE ports, or a range of PoE ports with the preceding
interface (to configure) command. If you specify a range or list of ports they must
all be PoE capable ports.
If you select a range of PoE ports in Interface Configuration mode before issuing
this command, then each port in the range selected will have the same maximum
power value configured. If the PoE port attempts to draw more than the maximum
power, this is logged and all power is removed. Note that the value entered is
rounded up to the next value supported by the hardware.
See the actual value used, as shown after command entry, in the sample console
output below:
See the LLDP Feature Overview and Configuration Guide for information about
power monitoring at the PD.
Note the difference in power supplied from the PSE to the power available at the
PD due to line loss.
Parameter Description
<4000-30000>
awplus#configure terminal
awplus(config-if)#power-line max 5300
% The maximum power has been rounded to 5450mW in hardware.
To Next Page
Loading...
