C613-50055-01 REV A Command Reference for x230 Series Edge Switches 131
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
EDIT
(FILENAME)
edit (filename)
Overview This command opens a remote text file as read-only in the AlliedWare Plus™ text
editor.
Before starting the editor make sure your terminal, terminal emulation program, or
Telnet client is 100% compatible with a VT100 terminal. The editor uses VT100
control sequences to display text on the terminal.
Syntax
edit <filename>
Mode Privileged Exec
Usage The filename and path can include characters from up to four categories. The
categories are:
1) uppercase letters: A to Z
2) lowercase letters: a to z
3) digits: 0 to 9
4) special symbols: all printable ASCII characters not included in the previous
three categories. Including the following characters:
•-
•/
•.
•_
•@
•"
•'
•*
•:
•~
•?
Do not use spaces or parentheses within filenames. Use hyphens or underlines
instead.
Parameter Description
<filename> The filename and path of the remote file. See Introduction on
page 106 for valid syntax.
To Next Page
Loading...
