32
1093 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
DHCP Snooping
Commands
Introduction
Overview This chapter gives detailed information about the commands used to configure
DHCP snooping. For detailed descriptions of related ACL commands, see IPv4
Hardware Access Control List (ACL) Commands. For more information about DHCP
snooping, see the DHCP Snooping Feature Overview and Configuration Guide.
DHCP snooping can operate on static link aggregators (e.g. sa2) and dynamic link
aggregators (e.g. po2), as well as on switch ports (e.g. port1.0.2).
Command List •“arp security” on page 1095
•“arp security violation” on page 1096
•“clear arp security statistics” on page 1098
•“clear ip dhcp snooping binding” on page 1099
•“clear ip dhcp snooping statistics” on page 1100
•“debug arp security” on page 1101
•“debug ip dhcp snooping” on page 1102
•“ip dhcp snooping” on page 1103
•“ip dhcp snooping binding” on page 1104
•“ip dhcp snooping database” on page 1105
•“ip dhcp snooping delete-by-client” on page 1106
•“ip dhcp snooping delete-by-linkdown” on page 1107
•“ip dhcp snooping max-bindings” on page 1108
•“ip dhcp snooping trust” on page 1109
•“ip dhcp snooping verify mac-address” on page 1110
•“ip dhcp snooping violation” on page 1111
•“ip source binding” on page 1112
To Next Page
Loading...
