946 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AAA COMMANDS
AAA
ACCOUNTING AUTH-WEB DEFAULT
aaa accounting auth-web default
Overview This command configures a default accounting method list for Web-based Port
Authentication. The default accounting method list specifies what type of
accounting messages are sent and specifies which RADIUS Servers the accounting
messages are sent to. The default accounting method list is automatically applied
to interfaces with Web-based Authentication enabled.
Use the no variant of this command to disable AAA accounting for Web-based Port
Authentication globally.
Syntax
aaa accounting auth-web default {start-stop|stop-only|none}
group {<group-name>|radius}
no aaa accounting auth-web default
Default RADIUS accounting for Web-based Port Authentication is disabled by default.
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages are sent:
• group radius : use all RADIUS servers configured by radius-server host
command
• group <group-name> : use the specified RADIUS server group configured
with the aaa group server command
Configure the accounting event to be sent to the RADIUS server with the following
options:
• start-stop : sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
• stop-only : sends a stop accounting message at the end of a session.
• none : disables accounting.
Examples To enable RADIUS accounting for Web-based Authentication, and use all available
RADIUS Servers, use the commands:
awplus# configure terminal
awplus(config)# aaa accounting auth-web default start-stop
group radius
Parameter Description
start-stop Start and stop records to be sent.
stop-only Stop records to be sent.
none No accounting record to be sent.
<group-name> Server group name.
radius Use all RADIUS servers.
To Next Page
Loading...
Need help?
General
