Allied Telesis AlliedWare Plus AT-x230-10GP - Auth-Web-Server Dhcp Ipaddress

888 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
-WEB-SERVER DHCP IPADDRESS
auth-web-server dhcp ipaddress
Overview Use this command to assign an IP address and enable the DHCP service on the
Web-Authentication server for supplicants (client devices).
Use the no variant of this command to remove an IP address and disable the DHCP
service on the Web-Authentication server for supplicants.
Syntax
auth-web-server dhcp ipaddress <ip-address/prefix-length>
no auth-web-server dhcp ipaddress
Default No IP address for the Web-Authentication server is set by default.
Mode Global Configuration
Usage See the Authentication Feature Overview and Configuration Guide for information
about:
• using DHCP with web authentication, and
• restrictions regarding combinations of authentication enhancements
working together
Examples To assign the IP address 10.0.0.1 to the Web-Authentication server, use the
following commands:
awplus# configure terminal
awplus(config)# auth-web-server dhcp ipaddress 10.0.0.1/8
To remove an IP address on the Web-Authentication server, use the following
commands:
awplus# configure terminal
awplus(config)# no auth-web-server dhcp ipaddress
Validation
Commands
show running-config
Related
Commands
show auth-web-server
auth-web-server dhcp lease
Parameter Description
<ip-addr/
prefix-length>
The IPv4 address and prefix length assigned for the DHCP
service on the Web-Authentication server for supplicants.