C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1353
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SNMP COMMANDS
SNMP
-SERVER ENABLE TRAP
snmp-server enable trap
Overview Use this command to enable the device to send the specified notifications (traps).
Note that the Environmental Monitoring traps are enabled by default. So you do
not need to issue this command for the Environmental Monitoring traps since
these are enabled by default. SNMP environmental monitoring traps defined in
AT-ENVMONv2-MIB are enabled by default.
Use the no variant of this command to disable the sending of the specified
notifications.
Syntax
snmp-server enable trap
{[atmf][atmflink][atmfnode][atmfrr][auth] [dhcpsnooping]
[epsr] [lldp] [loopprot] [mstp] [nsm] [ospf] [pim] [rmon]
[thrash-limit]}
no snmp-server enable trap
{[atmf][atmflink][atmfnode][atmfrr][auth] [dhcpsnooping]
[epsr] [lldp] [loopprot] [mstp] [nsm] [ospf] [pim]]
[rmon] [thrash-limit]}
Default By default, no notifications are generated.
Parameter Description
atmf AMF traps.
atmflink AMF Link traps.
atmfnode AMF Node traps.
atmfrr AMF Reboot Rolling traps.
auth Authentication failure.
dhcpsnooping DHCP snooping and ARP security traps. These notifications must
also be set using the ip dhcp snooping violation command,
and/or the arp security violation command.
epsr EPSR traps.
lldp Link Layer Discovery Protocol (LLDP) traps. These notifications
must also be enabled using the lldp notifications command,
and/or the lldp med-notifications command.
loopprot Loop Protection traps.
mstp MSTP traps.
nsm NSM traps.
ospf OSPF traps.
pim PIM traps.
rmon RMON traps.
thrash-limit MAC address Thrash Limiting traps.
To Next Page
Loading...
