C613-50055-01 REV A Command Reference for x230 Series Edge Switches 873
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
TIMEOUT SUPP-TIMEOUT
auth timeout supp-timeout
Overview This command sets the timeout of the waiting response from the supplicant (client
device) on a given interface.
The no variant of this command resets the supplicant timeout to the default (30
seconds).
Syntax
auth timeout supp-timeout <1-65535>
no auth timeout supp-timeout
Default The supplicant timeout of port authentication is 30 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To set the server timeout to 2 seconds for interface port1.0.2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth timeout supp-timeout 2
To reset the server timeout to the default (30 seconds) for interface port1.0.2,
use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth timeout supp-timeout
Validation
Commands
show dot1x
show dot1x interface
show running-config
Parameter Description
<1-65535> Seconds.
To Next Page
Loading...
