Allied Telesis AlliedWare Plus AT-x230-10GP - Atmf Controller

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1185
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
ATMF
CONTROLLER
atmf controller
Overview Use this command to configure the device as an AMF controller. This enables you
to split a large AMF network into multiple areas.
The number of areas supported on a controller depends on the license installed on
that controller.
Syntax
atmf controller
no atmf controller
Mode Global configuration
Usage A valid AMF license must be available before this command can be applied.
Example To configure the node named controller-1 as an AMF controller, use the
commands:
controller-1# configure terminal
controller-1(config)# atmf controller
To stop the node named controller-1 from being an AMF controller, use the
commands:
controller-1# configure terminal
controller-1(config)# no atmf controller
Related
Commands
atmf area
show atmf