C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1229
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AMF COMMANDS
DEBUG
ATMF
debug atmf
Overview This command enables the AMF debugging facilities, and displays information
that is relevant (only) to the current node. The detail of the debugging displayed
depends on the parameters specified.
If no additional parameters are specified, then the command output will display all
AMF debugging information, including link events, topology discovery messages
and all notable AMF events.
The no variant of this command disables either all AMF debugging information, or
only the particular information as selected by the command’s parameters.
Syntax
debug atmf
[link|crosslink|arealink|database|neighbor|error|all]
no debug atmf
[link|crosslink|arealink|database|neighbor|error|all]
Default All debugging facilities are disabled.
Mode User Exec and Global Configuration
Usage If no additional parameters are specified, then the command output will display all
AMF debugging information, including link events, topology discovery messages
and all notable AMF events.
NOTE: An alias to the no variant of this command is undebug atmf on page 1290.
Examples To enable all AMF debugging, use the command:
node_1# debug atmf
To enable AMF uplink and downlink debugging, use the command:
node_1# debug atmf link
To enable AMF error debugging, use the command:
node_1# debug atmf error
Parameter Description
link Output displays debugging information relating to uplink or
downlink information.
crosslink Output displays all crosslink events.
arealink Output displays all arealink events.
database Output displays only notable database events.
neighbor Output displays only notable AMF neighbor events.
error Output displays AMF error events.
all Output displays all AMF events.
To Next Page
Loading...
Need help?
General
