Allied Telesis AlliedWare Plus AT-x230-10GP - Page 858

858 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
HOST-MODE
Examples To set the host mode to multi-supplicant on interface port1.0.2, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth host-mode multi-supplicant
To set the host mode to default (single host) on interface port1.0.2, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth host-mode
Validation
Commands
show dot1x
show dot1x interface
show running-config