C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1285
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SWITCHPORT
ATMF-CROSSLINK
Example 2B To make static aggregator sa1 an AMF crosslink, use the following commands for
good practice:
Node_1# configure terminal
Node_1(config)# interface sa1
Node_1(config-if)# switchport atmf-crosslink
Node_1(config-if)# switchport trunk allowed vlan add 2
Node_1(config-if)# switchport trunk native vlan none
In this example VLAN 2 is assigned to the static aggregator, and the native VLAN
(VLAN 1) is explicitly excluded from the aggregated ports and the crosslink
assigned to it.
NOTE: The AMF management and domain VLANs are automatically added to the
aggregator and the crosslink.
Related
Commands
show atmf links statistics
To Next Page
Loading...
