222 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM PLUGGABLE DETAIL
• Diagnostic Calibration: Specifies whether the pluggable transceiver
supports DDM or DOM Internal or External Calibration.
– Internal is displayed if the pluggable transceiver supports DDM or
DOM Internal Calibration.
– External is displayed if the pluggable transceiver supports DDM or
DOM External Calibration.
– - is displayed if SFP DDM Internal Calibration or External Calibration is
not supported.
• Power Monitoring: Displays the received power measurement type, which
can be either OMA(Optical Module Amplitude) or Avg(Average Power)
measured in μW.
NOTE: For parameters that are not supported or not specified, a hyphen is displayed
instead.
Example To display detailed information about the pluggable transceivers installed in a
particular port on the device, use a command like:
awplus# show system pluggable port1.0.9 detail
To display detailed information about all the pluggable transceivers installed on
the device, use the command:
awplus# show system pluggable detail
To Next Page
Loading...
