Allied Telesis AlliedWare Plus AT-x230-10GP - Page 223

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 223
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM PLUGGABLE DETAIL
Output Figure 5-21: Example output from the show system pluggable detail
command on a device
awplus#show system pluggable detail
System Pluggable Information Detail
Port1.0.9
==========
Vendor Name: ATI
Device Name: AT-SP10SR
Device Type: 10GBASE-SR
Serial Number: A04440R1112200058
Manufacturing Datecode: 11052300
SFP Laser Wavelength: 850nm
Link Length Supported
Single Mode Fiber : -
OM1 (62.5um) Fiber: 30m
OM2 (50um) Fiber : 80m
Diagnostic Calibration: Internal
Power Monitoring: Average
FEC BER support: -
Table 5-7: Parameters in the output from the show system pluggables detail
command:
Parameter Description
Port Specifies the port the pluggable transceiver is installed in.
Vendor Name Specifies the vendor’s name for the installed pluggable
transceiver.
Device Name Specifies the device name for the installed pluggable
transceiver.
Device Type Specifies the device type for the installed pluggable
transceiver..
Serial Number Specifies the serial number for the installed pluggable
transceiver.
Manufacturing
Datecode
Specifies the manufacturing datecode for the installed
pluggable transceiver. Checking the manufacturing
datecode with the vendor may be useful when
determining Laser Diode aging issues. For more
information, see ”How To Troubleshoot Fiber and
Pluggable Issues” in the “Getting Started with AlliedWare
Plus” Feature Overview and Configuration Guide.
SFP Laser Wavelength Specifies the laser wavelength of the installed pluggable
transceiver.
Single Mode Fiber Specifies the link length supported by the pluggable
transceiver using single mode fiber.