1312 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
NTP COMMANDS
SHOW
COUNTER NTP
Example To display counters for NTP, use the command:
awplus# show counter ntp
Pkts bad
length
The number of NTP packets received that do not conform to the
standard packet length. NTP drops these packets.
Pkts bad auth The number of NTP packets received that failed authentication.
NTP drops these packets. Packets can only fail authentication if
NTP authentication is enabled with the ntp authenticate
command.
Pkts rate
exceed
The number of packets dropped because the packet rate
exceeded its limits.
Table 37-1: Parameters in the output from the show counter ntp command
Parameter Description
To Next Page
Loading...
Need help?
General
