1246 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF AREA NODES-DETAIL
The following figure shows partial example output from running this command.
Related
Commands
show atmf area
show atmf area nodes
Table 35-12: Output from the show atmf area nodes-detail command
controller-1#show atmf area nodes-detail
Wellington Area Node Information:
Node name well-gate
Parent node name : well-master
Domain id : well-gate’s domain
Board type : 368
Distance to core : 1
Flags : 50
Extra flags : 0x00000006
MAC Address : 001a.eb56.9020
Node name well-master
Parent node name : none
Domain id : well-master’s domain
Board type : 333
Distance to core : 0
Flags : 51
Extra flags : 0x0000000c
MAC Address : eccd.6d3f.fef7
...
Table 35-13: Parameter definitions from the show atmf area nodes-detail command
Parameter Definition
Node name The name assigned to a particular node.
Parent node name The node to which the current node has an active uplink.
Domain id
Board type The Allied Telesis code number for the device.
Distance to core The number of nodes in the path from the current node to the master node in its
area.
Flags Internal AMF information
Extra flags Internal AMF information
MAC Address The MAC address of the current node
To Next Page
Loading...
