400 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
VLAN COMMANDS
SWITCHPORT
VOICE VLAN
“Egress-VLAN-Name (58)” in the RADIUS Accept message when authenticating a
phone attached to this port.
To set these attributes on the local RADIUS server, use the egress-vlan-id command
or the egress-vlan-name command.
To tell IP phones connected to port1.0.5 to send voice data tagged for VLAN
10, use the commands:
To tell IP phones connected to ports 1.0.2-1.0.6 to send priority tagged packets
(802.1p priority tagged with VID 0, so that they will be assigned to the port VLAN)
use the following commands. The priority value is 5 by default, but can be
configured with the switchport voice vlan priority command.
awplus# configure terminal
awplus(config)# interface port1.0.2-port1.0.6
awplus(config-if)# switchport voice vlan dot1p
To dynamically configure the VLAN ID advertised to IP phones connected to
port1.0.1 based on the VLAN assigned by RADIUS authentication (with RADIUS
attribute “Egress- VLANID” or “Egress-VLAN-Name” in the RADIUS accept packet),
use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# switchport voice vlan dynamic
To remove the Voice VLAN, and therefore disable the transmission of LLDP-MED
network policy information for voice devices on port1.0.6, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no switchport voice vlan
To Next Page
Loading...
