Allied Telesis AlliedWare Plus AT-x230-10GP - Page 1241

C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1241
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF AREA
Example 2 To show detailed information about the areas, use the command:
controller-1# show atmf area detail
The following figure shows example output from running this command.
Related
Commands
show atmf area summary
show atmf area nodes
show atmf area nodes-detail
Area Count The number of areas controlled by the controller.
Area Node Count The total number of nodes in the area.
Table 35-7: Parameter definitions from the show atmf area command (cont.)
Parameter Definition
Table 35-8: Output from the show atmf area detail command
controller-1#show atmf area detail
ATMF Area Detail Information:
Controller distance : 0
Controller Id : 21
Backup Available : FALSE
Area Id : 2
Gateway Node Name : controller-1
Gateway Node Id : 342
Gateway Ifindex : 6013
Masters Count : 1
Master Node Name : well-master (329)
Node Count : 2
Area Id : 3
Gateway Node Name : controller-1
Gateway Node Id : 342
Gateway Ifindex : 4511
Masters Count : 2
Master Node Name : cant1-master (15)
Master Node Name : cant2-master (454)
Node Count : 2