C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1397
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LLDP COMMANDS
LOCATION
CIVIC-LOCATION CONFIGURATION
parameters—enough to consistently and precisely identify the location of the
device. If the location is to be used for Emergency Call Service (ECS), the particular
ECS application may have guidelines for configuring the civic address location. For
more information about civic address format, see the LLDP Feature Overview and
Configuration Guide.
To specify the civic address location, use the location civic-location identifier
command. To delete the civic address location, use the no variant of the location
civic-location identifier command. To assign the civic address location to
particular ports, so that it can be advertised in TLVs from those ports, use the
command location civic-location-id command.
Examples To configure civic address location 1 with location "27 Nazareth Avenue,
Christchurch, New Zealand" in civic-address format, use the commands:
awplus# configure terminal
awplus(config)# location civic-location identifier 1
awplus(config-civic)# country NZ
awplus(config-civic)# city Christchurch
awplus(config-civic)# primary-road-name Nazareth
awplus(config-civic)# street-suffix Avenue
awplus(config-civic)# house-number 27
Related
Commands
location civic-location-id
location civic-location identifier
show lldp local-info
show location
To Next Page
Loading...
