302 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
INTERFACE COMMANDS
SHOW
INTERFACE
To display configuration and status information for interfaces vlan1 and vlan2,
use the command:
awplus# show interface vlan1,vlan2
Figure 8-3: Example output from the show interface vlan1,vlan2 command
Related
Commands
mru
mtu
show interface brief
awplus#show interface vlan1,vlan2
Interface vlan1
Scope: both
Link is UP, administrative state is UP
Hardware is VLAN, address is 0015.77e9.5c50
IPv4 address 192.168.1.1/24 broadcast 192.168.1.255
index 201 metric 1 mtu 1500
arp ageing timeout 300
<UP,BROADCAST,RUNNING,MULTICAST>
SNMP link-status traps: Disabled
Bandwidth 1g
input packets 295606, bytes 56993106, dropped 5, multicast packets 156
output packets 299172, bytes 67379392, multicast packets 0 broadcast packets 0
Time since last state change: 0 days 14:22:39
Interface vlan2
Scope: both
Link is DOWN, administrative state is UP
Hardware is VLAN, address is 0015.77e9.5c50
IPv4 address 192.168.2.1/24 broadcast 192.168.2.255
Description: ip_phone_vlan
index 202 metric 1 mtu 1500
arp ageing timeout 300
<UP,BROADCAST,MULTICAST>
SNMP link-status traps: Disabled
Bandwidth 1g
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 90, bytes 4244, multicast packets 0 broadcast packets 0
Time since last state change: 0 days 14:22:39
To Next Page
Loading...
