522 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
SHOW
POWER-INLINE
Related
Commands
show power-inline counters
show power-inline interface
Pri The current PoE priorities for PoE ports on the PSE, as
configured from a power-inline priority command:
• Low displays when the low parameter is issued. The
lowest priority for a PoE enabled port (default).
• High displays when the high parameter is issued. The
second highest priority for a PoE enabled port.
• Crit displays when the critical parameter is issued.
The highest priority for a PoE enabled port.
Oper The current PSE PoE port state when this command was
issued:
• Powered displays when there is a PD connected and
power is being supplied from the PSE.
• Disabled displays when supplying power would make
the PSE go over the power budget.
• Off displays when PoE has been disabled for the PoE
port.
• F ault displays when a PSE goes over its power
allocation.
Power The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
Device The description of the connected PD device if a description
has been added with the power-inline description
command. No description is shown for PDs not configured
with the power-inline description command.
Class The class of the connected PD, if power is being supplied to
the PD from the PSE. See the Power over Ethernet
Introduction chapter for further information about PD
classes and the power levels assigned per class.
Max (mW) The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following as displayed per PoE port:
• [U] if the power limit for a port was user configured (with
the power-inline max command).
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD
class.
Table 14-1: Parameters in the show power-inline command output (cont.)
Parameter Description
To Next Page
Loading...
