C613-50055-01 REV A Command Reference for x230 Series Edge Switches 609
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
MULTICAST COMMANDS
IP
MULTICAST ROUTE
To remove a specific downstream VLAN from an existing static multicast route
entry, specify the VLAN you want to remove with the <downstream-vlan-id>
parameter when entering the no variant of this command.
Examples To create a static multicast route for the multicast source IPv4 address 2.2.2.2
and group IPv4 address 224.9.10.11, specifying the upstream VLAN interface
as vlan10 and the downstream VLAN interface as vlan20, use the following
commands:
awplus# configure terminal
awplus(config)# ip multicast route 2.2.2.2 224.9.10.11 vlan10
vlan20
To create an IPv4 static multicast route for the multicast source IPv4 address
2.2.2.2 and group IP address 224.9.10.11, specifying the upstream VLAN
interface as vlan10 and the downstream VLAN range as vlan20-25, use the
following commands:
awplus# configure terminal
awplus(config)# ip multicast route 2.2.2.2 224.9.10.11 vlan10
vlan20-25
To remove the downstream VLAN 23 from the IPv4 static multicast route created
with the above command, use the following commands:
awplus# configure terminal
awplus(config)# no ip multicast route 2.2.2.2 224.9.10.11
vlan10 vlan23
To delete an IPv4 static multicast route for the multicast source IP address
2.2.2.2 and group IP address 224.9.10.11, use the following commands:
awplus# configure terminal
awplus(config)# no ip multicast route 2.2.2.2 224.9.10.11
Related
Commands
clear ip mroute
show ip mroute
To Next Page
Loading...
