EasyManuals Logo

Allied Telesis AlliedWare Plus AT-x230-10GP User Manual

Allied Telesis AlliedWare Plus AT-x230-10GP
1536 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #743 background imageLoading...
Page #743 background image
C613-50055-01 REV A Command Reference for x230 Series Edge Switches 743
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
DOS
To configure synflood DoS detection on port1.0.1, and shutdown the
interface if an attack is detected, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# dos synflood action shutdown
To configure teardrop DoS detection on port1.0.1, and shutdown the
interface if an attack is detected, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# dos teardrop action shutdown
Related
Commands
show dos interface

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus AT-x230-10GP and is the answer not in the manual?

Allied Telesis AlliedWare Plus AT-x230-10GP Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus AT-x230-10GP
CategorySwitch
LanguageEnglish

Related product manuals