Allied Telesis AlliedWare Plus AT-x230-10GP - Page 866

866 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
ROAMING ENABLE
Examples To enable the Roaming Authentication enable feature for interface port1.0.4,
after enabling 802.1X-Authentication, since an authentication method is required,
use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth roaming enable
To disable Roaming Authentication enable for port1.0.4, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# no auth roaming enable
Validation
Commands
show running-config
Related
Commands
auth-mac enable
auth roaming disconnected
auth-web enable
dot1x port-control
show auth-mac interface
show auth-web interface
show dot1x interface