DGS-6604 m clear dos prevention counter
CLI Reference Guide
92
clear dos prevention counter
Use this command to clear the counter of all attack types.
clear dos_prevention counter
Syntax None
Default None
Command Mode Global configuration.
Usage Guideline Use to reset counters of DoS prevention to zero.
Examples This example shows how to clear counters.
Below is an example of using the show dos_prevention command to display
the DoS frame counts:
Switch(config)# clear dos_prevention counter
Switch(config)#
Switch(config)#show dos_prevention
DoS Prevention Information
Action: Drop
Frame Counts: 242
DoS Type State
----------------------------------------------------
Land Attack Enabled
Blat Attack Enabled
Smurf Attack Enabled
TCP Null Enabled
TCP Xmas Enabled
TCP SYNFIN Enabled
TCP SYN SrcPort Less Than 1024 Enabled
To Next Page
Loading...
