DGS-6604 mm dot1x forward-pdu
CLI Reference Guide
173
dot1x forward-pdu
Use this command to allow a 1X-disabled interface to forward 802.1X BPDU.
Use the no form of this command to disable the forwarding function on a 1X-
disabled interface.
dot1x forward-pdu
no dot1x forward-pdu
Syntax None
Default 802.1x BPDU is not forwarded when 802.1x is disabled.
Command Mode Interface configuration
Usage Guideline This command is only valid for physical port interface.
When the 802.1X functionality is disabled, and dot1x forward-pdu is configured
for a port, the received 1x BPDU on the port will be flooded to the ports where
forward-pdu is enabled and that are in the same VLAN.
Example This example shows how to enable 802.1X forward-pdu on a given interface.
Verify the settings by entering the show dot1x auth-configuration command.
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x forward-pdu
To Next Page
Loading...
