DGS-6604 m show ipv6 rip interface
CLI Reference Guide
720
show ipv6 rip interface
To display the usability status of interfaces configured for IPv6 RIP, use the show
ipv6 rip interface command.
show ipv6 rip interface [IFNAME]
Default None
Command Mode User EXEC
Privileged EXEC
mode
Usage Guideline
Use the show ipv6 rip interface command to validate the IPv6 RIP status of an
interface and its configured addresses. The show ipv6 rip interface command
also displays the parameters that IPv6 RIP is using on this interface including
any configured features.
If the argument IFNAME is not used then all IPv6 RIP interfaces are displayed.
Example The following is sample output in vlan1 from the show ipv6 rip interface
command.
Syntax Description
IFNAME The specified interface type and interface number
Switch > enable
Switch # show ipv6 rip interface vlan1
vlan1 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IPv6 interface address:
fe80::a01:2ff:fe36:1/64
To Next Page
Loading...
