DGS-6604 m shutdown (interface)
CLI Reference Guide
789
shutdown (interface)
Use this command to disable the port interface. Use the no form of the command
to enable the port interface.
shutdown
no shutdown
Syntax None
Default Enabled
Command Mode Interface configuration
Usage Guideline Only physical port interfaces are valid for this configuration.
The command will change the state of a port to be disabled. In the disabled state,
the port will not be able to receive or transmit any packets. Using the no
shutdown command, the port will set the port to the enabled state. When a port is
shutdown (disabled), the link status will also be off.
Examples Below demonstrates using the shutdown command to set interface port eth3.1
to the disabled state
Switch(config)# interface eth3.1
Switch(config-if)# shutdown
To Next Page
Loading...
