DGS-6604 m poe port description
CLI Reference Guide
483
poe port description
Use the poe port description command to configure the PoE port specific
description. Use no form of this command to clear the existed description.
poe port description TEXT
no poe port description
Default The default value of this description is a zero-length string.
Command Mode Interface configuration.
Usage Guideline This command could be used to configure a per-port description to indicate the
type of powered device that is connected to the port.
Example This example shows how to configure the PoE port description.
Syntax Description
description String that describes the PoE ports specific information. The maximum length is
128 characters. The syntax is a general string that allows space.
Switch(config)# interface eth3.1
Switch(config-if)# poe port description For VOIP usage
To Next Page
Loading...
