DGS-6604 mm default-information originate (RIP IPv6)
CLI Reference Guide
149
default-information originate (RIP IPv6)
To originate a default IPv6 route into RIP, use the default-information originate
command. To remove the default IPv6 RIP route, use the no form of this
command.
default-information originate
no default-information originate
Syntax None
Default Disabled
Command Mode Router configuration
Usage Guideline Originating a default IPv6 route into RIP also forces the advertisement of the
route in router updates sent on the interface. The advertisement of the route
occurs regardless of whether the route is present in the IPv6 routing table.
Example The following example originates a default IPv6 route into RIP and advertises the
default route with all other routes.
Switch > enable
Switch # configure terminal
Switch (config) # router ipv6 rip
Switch (config-router) # default-information originate
To Next Page
Loading...
