DGS-6604 m clear running-config factory-defaults
CLI Reference Guide
114
clear running-config factory-defaults
Use this command to clear the system’s running configuration.
clear running-config factory-defaults
Syntax None
Command Mode Privileged EXEC at level 15
Usage Guideline The user can enter the clear running-config factory-defaults command to
clear the system configuration retained in Dynamic RAM.
Before using the clear running-config factory-defaults command, save a
backup of the configuration using the copy command or upload a configuration
profile into the system. When the clear running-config factory-defaults
command is entered, the system resets the running configuration with the factory
default settings.
Since the command clears all of system configuration settings including IP
parameters, any remote management applications will loose their connections.
Therefore, before proceeding, a confirmation should be applied. In addition, it is
suggested to reload a configuration file immediately after clearing the
configuration.
The clear running-config command clears all system configuration settings
including the MGMT-IP address which is set back to the factory default of
10.90.90.90/8.
Example The following example demonstrates how to clear system running configuration.
Switch# clear running-config factory-defaults
..............................
Switch#
To Next Page
Loading...
