DGS-6604 m show lldp local interface
CLI Reference Guide
818
show lldp local interface
To display the each physical interface information, which will be carried in the
LLDP TLVs and sent to neighbor devices, use the show lldp local interface
command.
show lldp local interface INTERFACE-ID [ , | - ] [brief | detail]
Default Not applicable
Command Mode EXEC mode or any configuration mode
Usage Guideline This command displays the each physical interface information currently
available for populating outbound LLDP advertisements. If the advertising TLVs
are classified as global information, e.g. System Name, use the command show
lldp to get them.
Example The following is sample output from the show lldp local interface command to
display outbound LLDP advertisements for eth4.4 in detailed mode.:
Syntax Description
INTERFACE-ID Displays the current available information advertised for LLDP specific
interfaces. Valid interfaces must be physical.
, (optional) Specify a series of interfaces or separate a range of interfaces from a
previous range. No spaces are permitted before or after the comma.
- (Optional) Specify a range of interfaces. No spaces are permitted before or after
the hyphen.
brief (Optional) Display the information in brief mode.
detail (Optional) Display the information in detailed mode.
If neither brief nor detail is specified, display the information in normal mode.
To Next Page
Loading...
