DGS-6604 ingress-checking
CLI Reference Guide
219
G
ingress-checking
Use the ingress-checking to enable ingress frame checking at a port. Use the
no ingress-checking to disable the ingress frame checking function.
ingress-checking
no ingress-checking
Syntax None
Default Enabled
Command Mode Interface configuration
Usage Guideline The valid interfaces for this command are physical ports.
Use the ingress-checking interface command to enable ingress checking at the
switch interfaces. When ingress checking is enabled, if the port is not a member
port of the VLAN associated with the incoming frames, the frames will be
dropped. Use the no ingress-checking interface command to disable this
function of a port.
Example This example shows how to set ingress checking to enabled at ethernet port 4.1.
Verify the settings by entering the show vlan interface command.
Switch(config)# interface eth4.1
Switch(config-if)# ingress-checking
To Next Page
Loading...
