DGS-6604 m show ip dvmrp route
CLI Reference Guide
640
show ip dvmrp route
Use this command to display DVMRP route information.
show ip dvmrp route [NETWORK-ADDRESS]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Display DVMRP route information.
Example This example shows how to display route information.
Display Field
Descriptions
Description of significant display fields.
Syntax Description
NETWORK-
ADDRESS
(Optional) Specifies the source network address and mask length be displayed.
If NETWORK-ADDRESS is not specified, all DVMRP routes will be displayed.
DGS-6600:15#show ip dvmrp route
State: H = Hold-down
Source Network Upstream Neighbor Metric Learned Interface State ExpTime
------------------ ----------------- ------ ------- --------- ----- ------------
10.0.0.0/8 10.78.62.51 1 Local vlan99 -
Total Entries: 1
DGS-6600:15#
Display Field Description
Source Network The address of the source IP address or source network.
Upstream neighbor The Next hop router to the source network.
0.0.0.0: This route is a local interface entry, and therefore it does not enable
DVMRP.
If the interface is a local entry, then the upstream neighbor displays its own
interface IP address.
Learned Indicates this route entry is a local interface. The other condition is dynamically
learned.
Interface The local Interface used to connect to the source network.
State Route state displays "H" if the DVMRP route is in "Hold-down" state.
ExpTime The time remaining until the entry is removed from the DVMRP routing table. A
dash note indicates this entry is not going to be removed (because it is a local
interface).
To Next Page
Loading...
