DGS-6604 mm default ipv6 nd prefix
CLI Reference Guide
150
default ipv6 nd prefix
This command is used to default the IPv6 RA prefix information.
default ipv6 nd prefix X:X::X:X/M
Default None
Command Mode VLAN interface configuration
Usage Guideline RA prefix entry must be created first.
Example This example shows how to default the IPv6 nd prefix instance:
Syntax Description
X:X::X:X/M IPv6 network address. This argument must be in the form documented in
RFC2373 where the address is specified in hexadecimal using 16-bit value
between colons.
X:X::X:X: IPv6 address
M: IPv6 prefix length
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # default ipv6 nd prefix 3ffe:501:ffff::/64
Switch (config-if) #
To Next Page
Loading...
