DGS-6604 m vlan-tunnel remove-inner-tag
CLI Reference Guide
929
vlan-tunnel remove-inner-tag
Use this command to strip off the packet’s inner tag (C-TAG; should the packet
have it) of the incoming packet. Use the no form of the command to keep the
packet's inner tag.
vlan-tunnel remove-inner-tag
no vlan-tunnel remove-inner-tag
Syntax None
Default Disabled
Command Mode Interface configuration (only available for UNI ports only).
Usage Guideline The command is available only for a UNI port. If an incoming packet has an inner
tag (C-TAG) and the packet is forwarded to a UNI port which is configured as
remove-inner-tag enabled, then the packet's inner tag is removed.
Example This example shows how to enable the vlan-tunnel remove-inner-tag in
Ethernet eth3.1
Verify the settings by entering show vlan-tunnel command.
Switch(config)#interface eth3.1
Switch(config-if)#vlan-tunnel remove-inner-tag
To Next Page
Loading...
